Home > Exhibition > Content
The operation of the laminated glass is as follows:
Jun 02, 2017

1, according to the requirements of cutting glass error is less than 2mm.

2, the glass cleaning agent to the oil, dry with a cloth and then clean the cotton cloth with acetone wipe degreasing, the glass surface can not have oil and attachments.

3, the clean three or two layers of white glass and tempered glass stacked, the middle put transparent film, the distance of 30 cm, surrounded by transparent tape, sealed tape, the four corners to be sealed once again, and then One of the sealing tape to cut a little glue the glue stick to the glue, then the hose began to glue, pay attention to the skin tube do not have air. The other end of the glass pierces a hole so that the air is drained.

4, if the bubble filling process, with a thin thin iron into the bubble {HotTag} position of a pull, the bubble came out.

5, made of glass into the sun for three hours for the finished product, the glass above do not put anything.

6, the glue inside the glass must be dry the day, can not wait for the next day and then sun.

7, the weather is not good, you can use 40W ordinary UV lamp, according to the 10-20mm spacing evenly distributed, according to the sun can be 40 minutes.

8, per square meter Glue: 0.38mm with glue 0.45kg, 0.76mm with 0.86kg glue, 1mm with the proportion of 1.14kg with glue, with how much with the number of curing agent is one thousandth, with A small amount of alcohol diluted into the glue after mixing.